This issue is usually caused by the filament not being fully inserted or by filament grinding (Wiki Page: What is Grinding Filament?). As a result, the filament cannot be fed into the feeder. The odometer sensor does not detect filament movement for an extended period, while the feeding motor continues running, which triggers this prompt.
Reinsert the filament, ensuring it is properly gripped by the Extruder Gear and that it is fed into the PTFE tube.
Use cutters to trim off the ground (damaged) section of the filament, then reinsert it into the Filament Inlet.
Open the CFS lite and remove the filament from the corresponding slot.
Check whether the filament is ground. If so, cut off the damaged section.
Reload the filament and insert it back into the Filament Inlet.