K2 Plus
This error is triggered when the strain gauge of the extruder is deformed or damaged. Possible causes include:
When the nozzle wipes across the nozzle wiper module, if the module is detached or deformed, the nozzle may hit the strain gauge, causing damage.
Other causes of mechanical damage to the strain gauge.
Check the strain gauge: Inspect if the strain gauge has been deformed or damaged by impact. If damaged, it may need to be replaced.
Check the nozzle wiper module: Confirm that the nozzle wiper module is properly installed, not detached or deformed. If the module is found to be detached or deformed, please reinstall or adjust its position.
Check if there is obvious damage to the strain gauge; if so, it needs to be replaced. Replace K2 Plus Strain Gauge
Check the installation of the nozzle wiper module to ensure it is secured and not deformed.
If the module is found to be detached or deformed, reinstall or adjust it.
Try restarting the device, click the Z-axis homing, and observe if the problem is resolved.