① The blue light mode is more precise than the infrared mode;
② Adiust the exposure time of the lR camera duning scanning to ensure moderate exposure. Overexposure is shown as red, while underexposure is shown as blue. In blue light mode, you
also need to adjust the appropriate laser intensity;
③ Try to maintain the optimal scanning distance. Generaly, the closer the scanner is to the obiect without losing tracking, the better the details.
④ During point cloud optimization, use a smaller point distance, when the object size is small, the point distance can be set to 0.1mm;
⑤ When meshing, ensure that the number of model faces is sufficiently large.
① Creally Scan software provides a multi-project merging feature, allowing you to obtain the complete mode of an object through multiple scans and merging;
② First scan the visible part to obtain a partial model, then flip the object and continue scanning by baclktracking to obtain a complete mode (this method is only applicable when the marker points are attached to the surface of the object).
When scanning smaller objects (such as small parts,smallfigures, etc.), you can put marker points on the scanning pad and scan in marker point mode.
Blue light mode requires reflective marker points.
Infrared mode, When the surface of the obiect does not have enough geometric features, you can stick reflective marker points on the surface of the object and scan in maker point mode.
When the surface of an object does not have rich geometric features but has rich textures (such as a vase, you can scan it directly in texture mode.
It needs to be calibrated when it is not being used for a long time (such as 3 months) or when the device experiences a collision.
Each calibration board is unique and corresponds to each scanner. They cannot be swapped. When using a cabraion bard for the fist time, it needs to be scanned once to bind to the scanner using the OR code on the back. Otherwise, it may affect calibration accuracy.
After each use. please carefully return the calibration board to its box for proper storage. Avoid contamination, scratching, or heavy pressure on the calibration board to prevent loss or
damage.
Connect the scanner to the computer, open the Creality Scan software, go to the [Device] interface, click on [Calibation],and perform calibration by following the animated instructions
① If using a desktop computer, it is recommended to connect to the USB 3.0 port on the back of the main unit (USB 3.0 and above ports ar usually blue or red).
② Confirm that the system used is Windows 10/11 64-bit.
③ The entire installation path for the scanner software Creality Scan must be in English.
④ If the scanner is not recognized by one of the USB 3.0 ports, you can plug it into another USB 3.0 ports to try (if the computer has USB 3.0 type-C port, you can use the Type A to C adapter within the box to connect it).
Note: you should unplug the power adapter before switching the USB 3.0 ports, and then resume power again after the switching.
① Check whether the computer configuration meets the minimum configuration requirements of the scanner;
② Please make sure to use the provided power adapter and make sure it is connected properly;
③ Open the Windows Device Manager and check if there is a "CR-Scan Raptor.." under "Cameras".
④ Open windows Settinas-Privacy-Camera, confirm whether the system camera permission is enabled, and ensure that desktop applications have permission to access the camera.
① Check whether the computer configuration meets the minimum configuration requirements of the scanner,
② Please make sure to use the provided power adapter and make sure it is connected properly;
③ Update the scanner to the latest firmware version
④ Use a separate USB Type A to Thunderbolt or USB3 adapter, Avoid using multi-functional, multi-device USB-C adapter.
⑤ lnstall CrealityScan directly in the App directory, Do not install it in a sub-directory under the App directory.
You can try to quickly re-insert the USB cable, or first connect the USB cable to the USB 3.0 interface on the PC, and then connect it to the USB-C interface of the scanner.