¶ New Features
-
Compatible with Ferret series scanners
-
New feedback function
¶ Optimize content
-
Optimize the Toast Notification when Otter and Ferret are connected to USB 2.0
-
Added mouse pointer interaction effect when hovering over the manual hole filling function
-
After the splicing is successful, the data list will display the spliced data by default
-
Optimized the number of slider adjustment gears. See the following figure for specific modification parameters:
Scanning device: The scanning range after scanning preview is adjusted to 5mm per gear
IR and RGB camera parameters: The dragging step size of the exposure/brightness adjustment slider is changed to 10
Point cloud fusion settings: When the point distance is less than 0.1mm, adjust 0.01mm per step; when the point distance is greater than 0.1mm, adjust 0.05mm per step
Mesh generation settings: change the parameter of the de - isolation item to adjust 0.5% per gear, change the unit of the number of patches to M, and adjust 0.05M per gear
Mesh Editing_Auto Hole Filling: The side length of the hole is adjusted by 5mm per gear
¶ Bug Fixes
- Fixed the issue that the insufficient disk space prompt was not popped up during the face restoration process;
- Fixed the issue that the firmware upgrade prompt for the Wi-Fi single handle was not popped up correctly;
- Fixed the memory shortage issue on some 8GB memory computers during AI head restoration;
- Fixed the issue where the marker point was displayed offset to the lower left corner when scanning the infrared frame point.