Added a pre-flush volume setting to address filament degradation issues on the i8. After a filament change, the printer prints thick lines on the wipe tower. This parameter specifies the volume of new filament used for pre-flushing. Set it to 0 to disable pre-flushing.
Thick-line spacing: Uses a minimum wipe tower flush line spacing of 120%. If the user-defined value exceeds 120%, that value is used.
Thick-line spacing = max(120%, user-defined setting)
Thick-line speed:
Speed = Pre-flush length slowdown factor × Maximum volumetric speed ÷ Cross-sectional area
Nozzle Diameter and Line Width Mapping
Nozzle Diameter |
Base Width for Thin Lines |
Base Width for Thick Lines |
0.2 mm |
0.25 mm |
0.5 mm |
0.4 mm |
0.5 mm |
1.0 mm |
0.6 mm |
0.75 mm |
1.2 mm |
0.8 mm |
1.0 mm |
1.4 mm |
Previously, unsupported paths in narrow solid infill regions could begin printing over an unsupported area at the default high speed, increasing the likelihood of print failure.
The new speed settings for unsupported solid infill and sloped-surface infill enable the detection of potentially unsupported paths in these regions and control their printing speed to reduce the risk of failure.
Added a Minimum Print Thickness parameter to address nozzle clogging during color-mixing and gradient printing.
Color-mixing sublayers are created by dividing the overall layer height according to each color’s proportion. Colors with a small proportion may produce excessively thin sublayers. This parameter sets a minimum thickness for each sublayer, reducing overly thin sublayers and improving printing stability.
The effectiveness of this setting in reducing clogging should be validated using the actual printer model, filament, and printing conditions.
1.Fixed an issue where updated online parameters did not take effect.
2.Added a temperature setting for the low-temperature heat-enhancing build plate.