This message indicates that during the feeding process, the CFS Lite failed to deliver the filament properly to the extruder filament sensor. Common causes include:
Check whether the placement of the i7 and CFS Lite, as well as the installation of the PTFE tube, are correct. Please refer to CFS Lite Filament Tube Installation and Placement Guidelines for detailed instructions.
If the placement is correct, first check whether the filament end is excessively curved. Use cutters to trim a short section from the filament end, then reinsert the filament into the CFS Lite.
If the issue persists and the error appears frequently, there may be an abnormality with the Toolhead Manifold or the Extruder. In this case, replacement may be required, or you may contact the SPARKX after-sales support team for assistance.
Refer to CFS Lite Filament Tube Installation and Placement Guidelines to ensure the printer placement and PTFE tube routing are correct.
If components related to the Toolhead Manifold or Extruder front housing need to be replaced, it is recommended to stop the print and power off the printer before performing the replacement.