K1 Max/K2 Plus
This prompt indicates that the Settings for the current print file do not support flow PA calibration, so the system will automatically use the default print parameters. This is usually due to file format or slice Settings not meeting flow calibration requirements.
Check the file: Make sure the print file format supports the flow PA calibration, it is recommended to use CrealityPrint 5.0 and above or Orcaslicer 2.0 and above for slicing.
Troubleshooting:
Step 1: Check whether the current printed file is using the recommended slicing software.
Step 2: Adjust the Settings or re-slice the file to make sure it supports flow PA calibration.
Step 3: After finishing slicing, restart the print task.