Q： Can the device name be changed?
A： Currently, changing the device name is not supported. It is recommended to distinguish devices by their IP addresses.
Q： What should I do if the computer cannot find the printer during WLAN printing?
A：
Q： How do I heat the resin? Does the device support temperature control?
A： The PioNext Ultra comes with a built-in chamber heating system. You can adjust the temperature on the device interface. It is recommended to preheat the resin when the room temperature is below 20°C.
Q： What should I do if the printed model has defects or holes?
A： Possible causes include:
Q： How can I easily remove supports after printing?
A： It is recommended to soak the printed part in alcohol for 2 minutes before removing supports, or simply use flush cutters to cut them off.
Q： The print results are not satisfactory. How can I improve them?
A： You need to adjust the support placement of the model in the slicing software; otherwise, some supports may fall off during printing. The printing speed should not be set too fast. Additionally, the resin used, slicing parameters, model orientation, and support conditions can also affect the print quality.