¶ Tools
Hex Wrench
New Nozzle Wiper Module
New Nozzle Wiper Adhesive Tape
¶ Nozzle Wiper Module Replacement Steps
¶ Removal
Use hex wrench to remove 2 screws securing the nozzle wiper module
Remove the nozzle wiper module
¶ Installation
Install the new nozzle wiper module
Use hex wrench to tighten 2 screws securing the nozzle wiper module
Use hex wrench to loosen 4 screws on the adjustment base so it can move up and down.
 |
 |
Move the toolhead to the nozzle wiper module, ensuring the nozzle contacts the metal dome.
Adjust the position of adjustment base to create slight scraping between metal dome and nozzle.
Secure the adjustment base position, use hex wrench to tighten the 4 screws
 |
 |
¶ Nozzle Wiper Adhesive Tape Replacement Steps
¶ Removal
Peel off the old adhesive tape.
¶ Installation
Remove the release paper from new adhesive tape
Apply the adhesive tape to the nozzle wiper module
¶ Friendly Reminder
If you still haven't resolved the issue after following the steps in this document, or if you encounter any difficulties during the process, you can click the right corner of the wiki page online support to contact our after-sales team for more help.