The HALOT-MAGE S feeding module is an optional accessory and must be purchased separately.
1、 Power off the device, remove the build plate and filament spool cap, then extract the feed module line.
2、 Remove the rear material tube cover, thread the feed tube from the supply module through the material tube hole at the back of the machine.
3、 Connect the module power supply cable at the bottom.
4、 Align the fixing screws on the middle plate and push the feeding module into place following the direction of the arrow. Power on the device, and the installation is complete.
5、 Feedstock Module Interface Definition
6、 Indicator Light Guide
Please ensure that the resin vat and material levels are normal before enabling the [Auto Mode].