¶ Phenomenon Description
After installing the optional insulation enclosure, friction occurs between the top cover and the nozzle bus.
¶ Cause Analysis
The nozzle bus is warped upward too high.
¶ Troubleshooting
1. First, print the wire harness conduit print part (at least two pieces). PETG filament is recommended for printing.
2. Install the conduit part starting from the sealed end of the nozzle bus, and make sure to organize the wire harness into the wire groove.
3. Combine the conduit parts.
4. Install the mounting parts onto the conduit parts, paying attention to distinguish the installation positions of large and small mounting parts.
