¶ The material rack model can be directly printed on the machine's local file.
model file：spoolholder-sidev2.stl
¶ 1、 Unload the original side's material rack and spool holder.
¶ 2、 Install the material rack on the right screws of the machine as shown in the picture. (Note: The support needs to be removed after printing completed)
¶ 3、 Rotate the spool holder into the material rack . (Note: The initial installment gap is narrower, and you need to rotate hard after it is stuck in)
¶ 4、 Load the filament into the spool holder, same as the input method.
¶ 5、 Now you can start to print.