¶ 1. Unload
Unload the original side's material rack and spool holder.
¶ 2. Install
Install the material rack on the right screws of the machine as shown in the picture. (Note: The support needs to be removed after printing completed)
¶ 3. Rotate
Rotate the spool holder into the material rack . (Note: The initial installment gap is narrower, and you need to rotate hard after it is stuck in)
¶ 4. Load
Load the filament into the spool holder, same as the input method.
¶ 5. Start to print
Printing Temporary File Link：spoolholder-sidev2.stl