¶ Connect Device
(Otter Lite Wireless Example)
1）Assemble the Otter Lite device following its instructions.
2） Press the power button on the lite bridge to turn on the device's Wi-Fi signal.
3） Connect your computer to the "Lite Bridge" Wi-Fi network. 。
¶ Preview
- Set scan parameters: Human - Geometry -Fast.
- Start preview. Check if exposure is correct. If the preview has too few points, manually adjust exposure until the model looks complete.
¶ Start Scanning
Scan the body in 4 parts, in this order:
¶ 1) Upper Front:
Scan the face first. Avoid the face afterward in case the movement occurs .
For difficult hair areas, adjust exposure/distance.
¶ 2）Upper Back:
Move from** the side of the arm** to the back.
Scan the back.
¶ 3) Lower Back:
Move down from the back.
Scan the back of the legs.
¶ 4) Lower Front:
Move from the side of the leg to the front.
Scan the front of the legs.
Check for missing areas and rescan if needed.
¶ Process Data
- After the scanning completed. Delete extra points,Set a suitable point distance for"Pointcloud Fusing" .
- Meshing:
Final human mesh data is ready.
